SNA_PRE SNAPRE_E01014 DIGITAL SNA Printer Emulator OpenVMS ECO Summary
TITLE: SNA_PRE SNAPRE_E01014 DIGITAL SNA Printer Emulator OpenVMS ECO Summary
********************** NOTE *********************
* *
* Engineering is currently researching a problem *
* with this ECO and requested that it be placed *
* on hold. *
* *
***************************************************
Modification Date: 11-JUN-99
Modification Type: Kit Placed on Engineering Hold.
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
The name of the compressed file will be kit_name-dcx_vaxexe
for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
Once the file is copied to your system, it can be expanded
by typing RUN compressed_file. The resultant file will
be the OpenVMS saveset or PCSI installation file which
can be used to install the ECO.
Copyright (c) Compaq Computer Corporation 1999. All rights reserved.
PRODUCT: DECnet SNA Printer Emulator for OpenVMS
OP/SYS: OpenVMS VAX
OpenVMS Alpha
SOURCE: Compaq Computer Corporation
ECO INFORMATION:
ECO Kit Name: SNAPRE_E01014
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: 2088 Blocks
Kit Applies To: DECnet SNA Printer Emulator for OpenVMS V1.4
OpenVMS VAX V6.2, V7.0, V7.1, V7.2
OpenVMS Alpha V6.2, V6.2-1H1, V6.2-1H2, V6.2-1H3,
V7.0, V7.1, V7.1-1H1, V7.1-1H2,
V7.1-2, V7.2
System/Cluster Reboot Necessary: No
Rolling Re-boot Supported: Not Applicable
Installation Rating: INSTALL_UNKNOWN
This information is not available
Kit Dependencies:
The following remedial kit(s) must be installed BEFORE
installation of this kit:
None
In order to receive all the corrections listed in this
kit, the following remedial kits should also be installed:
None
ECO KIT SUMMARY:
An ECO kit exists for SNA PRE V1.4 on OpenVMS V6.2 through V7.2.
Problems Addressed in the SNAPRE_E01014 Kit:
o Local OpenVMS Alpha users can now connect to Compaq SNA Server
without using a network connection. This is similar to OpenVMS
VAX local users connections to VMS/SNA. Example: $SET HOST/SNA 0.
o Fixed a problem where the connection failed to a gateway
because the terminal ID was longer than 32 bytes. The
following error was returned:
%SNA-E-INVTRMPAR, invalid authterm parameter
-SNA-E-LENTOOLON, transmit byte count exceeds buffer length
This problem would only occur while logged into a terminal
that is TELNETed from another system and the access is to a
PU2 gateway or VMS/SNA through GAS.
INSTALLATION NOTES:
The system/cluster does not need to be rebooted after this kit is
installed.
The ECO kit checks to ensure that a valid license is installed before
proceeding. If one is not found, the installation aborts.
All trademarks are the property of their respective owners.
This patch can be found at any of these sites:
Colorado Site
Georgia Site
Files on this server are as follows:
snapre_e01014.README
.CHKSUM
snapre_e01014.a-dcx_axpexe
snapre_e01014.a-dcx_vaxexe
snapre_e01014.CVRLET_
|
