OpenVMS VMS721_DQCONFIG-V0200 OpenVMS Alpha V7.2-1 DQCONFIG ECO Summary
TITLE: OpenVMS VMS721_DQCONFIG-V0200 OpenVMS Alpha V7.2-1 DQCONFIG ECO Summary
Modification Date: 25-JAN-2000
Modification Type: Updated Kit: Supersedes VMS721_DQCONFIG-V0100
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
The name of the compressed file will be kit_name-dcx_vaxexe
for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
Once the file is copied to your system, it can be expanded
by typing RUN compressed_file. The resultant file will
be the OpenVMS saveset or PCSI installation file which
can be used to install the ECO.
Copyright (c) Compaq Computer Corporation 1999, 2000. All rights reserved.
PRODUCT: OpenVMS Alpha
COMPONENT: DQCONFIG
SOURCE: Compaq Computer Corporation
ECO INFORMATION:
ECO Kit Name: VMS721_DQCONFIG-V0200
DEC-AXPVMS-VMS721_DQCONFIG-V0200--4.PCSI
ECO Kits Superseded by This ECO Kit: VMS721_DQCONFIG-V0100
DEC-AXPVMS-VMS721_DQCONFIG-V0100--4.PCSI
ECO Kit Approximate Size: 144 Blocks
Kit Applies To: OpenVMS Alpha V7.2-1
System/Cluster Reboot Necessary: Yes
Rolling Re-boot Supported: Yes
Installation Rating: INSTALL_3
3 - To be installed on all systems running
the listed versions of OpenVMS which
are experiencing the problems described.
Kit Dependencies:
The following remedial kit(s) must be installed BEFORE
installation of this kit:
None
In order to receive all the corrections listed in this
kit, the following remedial kits should also be installed:
None
ECO KIT SUMMARY:
An ECO kit exists for DQCONFIG on OpenVMS Alpha V7.2-1. This kit
addresses the following problems:
Problems Addressed in VMS721_DQCONFIG-V0200:
o Use of a CD-ROM on a high performance Alpha system may cause
the PCI bus on the system to hang.
Images Affected: [SYS$LDR]SYS$DQDRIVER.EXE
Problems Addressed in VMS721_DQCONFIG-V0100:
o When a system that includes IDE/ATA or ATAPI drives is booted
from one of these devices, a second unit on the same IDE bus
will not autoconfigure. For example, if system boot is from
DQA0:, drive DQA1: will not be auto-configured. Currently, the
only systems affected are the DS10/VS10/XP90.
Images Affected: [SYS$LDR]SYS$ICBM.EXE
o ES40 machines crash when a KZPAC is installed in Hose 0 and an
attempt is made to mount a CD-ROM. This problem is also seen,
to a lesser degree, on other platforms.
Images Affected: [SYS$LDR]SYS$DQDRIVER.EXE
o Remove DMA support on the following platforms:
+ DPWS-xxxau
+ XP1000
+ DS20
+ DS20E
+ SMARTengine 21264/Alpha PCI/ISA SBC
Images Affected: [SYS$LDR]SYS$DQDRIVER.EXE
INSTALLATION NOTES:
Install this kit with the POLYCENTER Software installation utility
by logging into the SYSTEM account, and typing the following at the
DCL prompt:
PRODUCT INSTALL VMS721_DQCONFIG /SOURCE=[location of Kit]
The kit location may be a tape drive, CD, or a disk directory that
contains the kit.
Additional help on installing PCSI kits can be found by typing
HELP PRODUCT INSTALL at the system prompt
The images in this kit will not take effect until the system is
rebooted. If there are other nodes in the VMScluster, they must
also be rebooted in order to make use of the new image(s).
If it is not possible or convenient to reboot the entire cluster at
this time, a rolling re-boot may be performed.
All trademarks are the property of their respective owners.
This patch can be found at any of these sites:
Colorado Site
Georgia Site
Files on this server are as follows:
dec-axpvms-vms721_dqconfig-v0200--4.README
dec-axpvms-vms721_dqconfig-v0200--4.CHKSUM
dec-axpvms-vms721_dqconfig-v0200--4.pcsi-dcx_axpexe
vms721_dqconfig-v0200.CVRLET_TXT
|