OpenVMS VAXCLIU02_U2055 VAX V5.5-2__V5.5-2H4 DYNSWITCH ECO Summary

 
NOTE:  An OpenVMS saveset or PCSI installation file is stored
       on the Internet in a self-expanding compressed file.
       The name of the compressed file will be kit_name-dcx_vaxexe
       for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
 
       Once the file is copied to your system, it can be expanded
       by typing RUN compressed_file.  The resultant file will
       be the OpenVMS saveset or PCSI installation file which
       can be used to install the ECO.
 
Copyright (c) Digital Equipment Corporation 1994. All rights reserved.

OP/SYS:      OpenVMS VAX

COMPONENTS:  DYNSWITCH.EXE 

SOURCE:      Digital Equipment Corporation

ECO INFORMATION:

     ECO Kit Name:  VAXCLIU02_U2055
     ECO Kits Superseded by This ECO Kit:  None
     ECO Kit Approximate Size:  75 blocks
     Kit Applies To:  OpenVMS VAX V5.5-2, V5.5-2H4
     System Reboot Necessary:  Yes


ECO KIT SUMMARY:

An ECO kit exists for DYNSWITCH.EXE on OpenVMS VAX V5.5-2 through
V5.5-2H4.  This kit addresses the following problems: 
 
Problems addressed in the VAXCLIU02_U2055 kit:

  o  When attempting to setup dynamic asynchronous DECNET, if noise
     appears on the line before the DDCMP protocol has been
     successfully established, an infinite loop can be entered.  The
     process ties up 100% of the CPU resources and will remain in
     this state until it is manually stopped.


INSTALLATION NOTES:

In order for the corrections in this kit to take effect, the system
must be rebooted.  If the system is a member of a VAXcluster,
the entire cluster should be rebooted.

Colorado Site
Georgia Site

vaxcliu02_u2055.README
vaxcliu02_u2055.CHKSUM
vaxcliu02_u2055.CVRLET_TXT
vaxcliu02_u2055.a-dcx_vaxexe