OpenVMS ALPINIT01_071 Alpha V7.1 INIT$SHR ECO Summary
TITLE: OpenVMS ALPINIT01_071 Alpha V7.1 INIT$SHR ECO Summary
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
The name of the compressed file will be kit_name-dcx_vaxexe
for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
Once the file is copied to your system, it can be expanded
by typing RUN compressed_file. The resultant file will
be the OpenVMS saveset or PCSI installation file which
can be used to install the ECO.
Copyright (c) Compaq Computer Corporation 1998. All rights reserved.
Modification Date: 26-FEB-1999
Modification Type: Dependent kit ALPMOUN05_071 has been superseded by
ALPMOUN06_071.
NOTE: The documentation for this kit calls out a dependency on the
ALPMOUN05_071 remedial kit. This MOUNT kit has been superseded
by ALPMOUN06_071.
Modification Date: 22-DEC-1998
Modification Type: Modified Installation Rating from "1" to "2".
PRODUCT: OpenVMS Alpha
COMPONENT: INIT - INIT$SHR.EXE
SOURCE: Compaq Computer Corporation
ECO INFORMATION:
ECO Kit Name: ALPINIT01_071
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: 360 Blocks
Kit Applies To: OpenVMS Alpha V7.1 through V7.1-1H2
System/Cluster Reboot Necessary: No
Installation Rating: INSTALL_2
2 - To be installed on all systems running
the listed version(s) of OpenVMS and
using the following feature(s):
Host-based RAID and MME
Kit Dependencies:
The following remedial kit(s) must be installed BEFORE
installation of this kit:
None
In order to receive all the corrections listed in this
kit, the following remedial kits should also be installed:
ALPSYSA02_071
ALPBACK03_071
ALPDISM01_071
ALPMOUN05_071
ALPMTAA01_071
ECO KIT SUMMARY:
An ECO kit exists for INIT$SHR.EXE on OpenVMS Alpha V7.1 through V7.1-1H2.
This kit addresses the following problems:
Problems Addressed in ALPINIT01_071:
o A possible system crash occurs during Host Based RAID Unbinds
with MME code enabled. A mailbox read synchronization problem
causes the crash.
This problem only occurs when a host-based RAID UNBIND command
is done while an MME-based application is running.
This problem may occur in several different code areas of the
operating system. In order to eliminate all instances of this
problem, the following remedial kits (or their supersedants)
will also need to be installed:
ALPSYSA02_071
ALPBACK03_071
ALPDISM01_071
ALPMOUN05_071
ALPMTAA01_071
INSTALLATION NOTES:
Install this kit with the VMSINSTAL utility by logging into the
SYSTEM account, and typing the following at the DCL prompt:
@SYS$UPDATE:VMSINSTAL ALPINIT01_071 [location of the saveset]
The saveset location may be a tape drive, or a disk directory that
contains the kit saveset.
No reboot is necessary after successful installation of the kit.
However, if the system is a member of a VMScluster, the other cluster
members should be rebooted or this kit should be installed on each
system in order to make use of the new image.
This patch can be found at any of these sites:
Colorado Site
Georgia Site
Files on this server are as follows:
alpinit01_071.README
alpinit01_071.CHKSUM
alpinit01_071.CVRLET_TXT
alpinit01_071.a-dcx_axpexe
|