OpenVMS VAXINIT01_071 OpenVMS VAX V7.1 ECO Summary
TITLE: OpenVMS VAXINIT01_071 OpenVMS VAX V7.1 ECO Summary
Modification Date: 18-DEC-98
Modification Type: New Kit
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
The name of the compressed file will be kit_name-dcx_vaxexe
for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
Once the file is copied to your system, it can be expanded
by typing RUN compressed_file. The resultant file will
be the OpenVMS saveset or PCSI installation file which
can be used to install the ECO.
Copyright (c) Compaq Computer Corporation 1998. All rights reserved.
NOTE: The documentation for this kit calls out a dependency on the
VAXMOUN04_071 remedial kit. This MOUNT kit is not currently
available but will be released at a future date.
OP/SYS: DIGITAL OpenVMS VAX
COMPONENT: INIT$SHR
SOURCE: Compaq Computer Corporation
ECO INFORMATION:
ECO Kit Name: VAXINIT01_071
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: 144 Blocks
Kit Applies To: OpenVMS VAX V7.1
System/Cluster Reboot Necessary: No
Rolling Re-boot Supported: Not Applicable
Installation Rating: INSTALL_3
3 - To be installed on all systems running
the listed versions of OpenVMS which
are experiencing the problems described.
Kit Dependencies:
The following remedial kit(s) must be installed BEFORE
installation of this kit:
None
In order to receive all the corrections listed in this
kit, the following remedial kits should also be installed:
VAXSYSA02_071
VAXBACK03_071
VAXMOUN04_071
VAXDISM01_071
VAXMTAA01_071
NOTE: The documentation for this kit calls out a dependency on the
VAXMOUN04_071 remedial kit. This MOUNT kit is not currently
available but will be released at a future date.
ECO KIT SUMMARY:
An ECO kit exists for INIT$SHR and MME on OpenVMS VAX V7.1. This kit
addresses the following problems:
o A possible system crash occurs during Host Based RAID Unbinds
with MME code enabled. A mailbox read synchronization problem
causes the crash.
This problem only occurs when a host-based RAID UNBIND command
is done while an MME-based application is running.
This problem can occur in several different code areas of the
operating system. In order to eliminate all known instances
of this problem, the following remedial kits (or their
supersedants) will also need to be installed:
VAXSYSA02_071
VAXBACK03_071
VAXMOUN04_071
VAXDISM01_071
VAXMTAA01_071
NOTE: The documentation for this kit calls out a dependency on the
VAXMOUN04_071 remedial kit. This MOUNT kit is not currently
available but will be released at a future date.
o A process using MME could potentially "miss" the VOL1 label on
a tape. Also, a process could "hang" trying to send a message
to the MME process.
INSTALLATION NOTES:
The system does not need to be rebooted after this kit is installed.
However, if the system is a member of a VMScluster, the other cluster
members should be rebooted or this kit should be installed on each
system in order to make use of the new image(s).
All trademarks are the property of their respective owners.
This patch can be found at any of these sites:
Colorado Site
Georgia Site
Files on this server are as follows:
vaxinit01_071.README
vaxinit01_071.CHKSUM
vaxinit01_071.CVRLET_TXT
vaxinit01_071.a-dcx_vaxexe
|