OpenVMS VAXDISM02_062 DISMOUNT for OpenVMS VAX V6.2 ECO Summary
TITLE: OpenVMS VAXDISM02_062 DISMOUNT for OpenVMS VAX V6.2 ECO Summary
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
The name of the compressed file will be kit_name-dcx_vaxexe
for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
Once the file is copied to your system, it can be expanded
by typing RUN compressed_file. The resultant file will
be the OpenVMS saveset or PCSI installation file which
can be used to install the ECO.
Copyright (c) Compaq Computer Corporation 1998. All rights reserved.
Modification Date: 18-MAR-1999
Modification Type: Article Updated as VAXMOUN03_062 is Now Available
Modification Date: 02-DEC-1998
Modification Type: Updated Article to list the dependent ECO
VAXMOUN03_062 as unavailable until a later date.
Modification Date: 20-NOV-1998
Modification Type: Updated ECO Kit - Supersedes VAXDISM01_062
OP/SYS: OpenVMS VAX
COMPONENT: DISMOUNT (DISMNTSHR.EXE)
SOURCE: Compaq Computer Corporation
ECO INFORMATION:
ECO Kit Name: VAXDISM02_062
ECO Kits Superseded by This ECO Kit: VAXDISM01_062 (for V6.2 only)
ECO Kit Size: 108 Blocks
Kit Applies To: OpenVMS VAX V6.2
System/Cluster Reboot Necessary: No
Installation Rating: INSTALL_3
3 - To be installed on all systems running
the listed versions of OpenVMS which
are experiencing the problems described.
KIT DEPENDENCIES:
The following remedial kit(s) must be installed BEFORE
installation of this, or any required kit:
VAXCLUSIO01_062
In order to receive all the corrections listed in this kit,
the following remedial kits should also be installed:
VAXSYSA02_062
VAXBACK03_062
VAXMOUN03_062
VAXINIT01_062
VAXMTAA03_062
ECO KIT SUMMARY:
An ECO kit exists for DISMOUNT on OpenVMS VAX V6.2. This kit addresses the
following problems:
Problems Addressed in VAXDISM02_062:
o A possible system crash occurs during Host Based RAID Unbinds
with MME code enabled. A mailbox read synchronization problem
causes the crash.
This problem only occurs when a host-based RAID UNBIND command
is done while an MME-based application is running.
This problem can occur in several different code areas of the
operating system. In order to eliminate all known instances of
this problem, the following remedial kits (or their
supersedants) will also need to be installed:
VAXSYSA02_062
VAXBACK03_062
VAXMOUN03_062
VAXINIT01_062
VAXMTAA03_062
o A process using MME could potentially "miss" the VOL1 label on
a tape. Also, a process could "hang" trying to send a message
to the MME process.
Problems Addressed in VAXDISM01_062:
o SSRVEXCEPT in DISMNTSHR when a user (or application) attempts to
DISMOUNT a tape that is in use by RTF/SLS.
This problem is corrected in OpenVMS VAX V7.0
INSTALLATION NOTES:
The system does not need to be rebooted after this kit is installed.
However, if the system is a member of a VMScluster, the other cluster
members should be rebooted or this kit should be installed on each
system in order to make use of the new image(s).
This patch can be found at any of these sites:
Colorado Site
Georgia Site
Files on this server are as follows:
vaxdism02_062.README
vaxdism02_062.CHKSUM
vaxdism02_062.CVRLET_TXT
vaxdism02_062.a-dcx_vaxexe
|
