OpenVMS VAXCLD01_071 VAX V7.1 Analyze ECO Summary
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
The name of the compressed file will be kit_name-dcx_vaxexe
for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
Once the file is copied to your system, it can be expanded
by typing RUN compressed_file. The resultant file will
be the OpenVMS saveset or PCSI installation file which
can be used to install the ECO.
Copyright (c) Digital Equipment Corporation 1998. All rights reserved.
OP/SYS: DIGITAL OpenVMS VAX
COMPONENT: ANALYZE.CLD
SOURCE: Digital Equipment Corporation
ECO INFORMATION:
ECO Kit Name: VAXCLD01_071
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: 126 Blocks
Kit Applies To: OpenVMS VAX V7.1
System/Cluster Reboot Necessary: No
Installation Rating: 3 - To be installed on all systems running
the listed versions of OpenVMS which
are experiencing the problems described.
NOTE: In order to receive the full fixes listed in this kit,
the following remedial kits also need to be installed:
None
ECO KIT SUMMARY:
An ECO kit exists for ANALYZE.CLD on OpenVMS VAX V7.1. This kit
addresses the following problems:
o The command ANAL/AUDIT/SELECT=(PRIVILEGES_USED=OPER) fails
with a syntax error on 'IMPERSONATE'.
INSTALLATION NOTES:
The system does not need to be rebooted after this ECO kit is
installed. However, the following commands should be executed
in order for all kit changes to take effect.
o Issue the command:
SET COMMAND SYS$UPDATE:ANALYZE.CLD
o To make the change permanent for the entire system issue the
command:
SET COMMAND/TABLE=SYS$LIBRARY:DCLTABLES/ -
This patch can be found at any of these sites:
Colorado Site
Georgia Site
Files on this server are as follows:
vaxcld01_071.README
vaxcld01_071.CHKSUM
vaxcld01_071.CVRLET_TXT
vaxcld01_071.a-dcx_vaxexe
|