OPEN3D OPEN3D_E10023 DEC Open3D V2.2__V2.3 for OpenVMS AXP ECO Summary

 
NOTE:  An OpenVMS saveset or PCSI installation file is stored
       on the Internet in a self-expanding compressed file.
       The name of the compressed file will be kit_name-dcx_vaxexe
       for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
 
       Once the file is copied to your system, it can be expanded
       by typing RUN compressed_file.  The resultant file will
       be the OpenVMS saveset or PCSI installation file which
       can be used to install the ECO.
 
Copyright (c) Digital Equipment Corporation 1995.  All rights reserved.

PRODUCT:    DEC Open3D for OpenVMS AXP

OP/SYS:     OpenVMS Alpha

SOURCE:     Digital Equipment Corporation

ECO INFORMATION:

     ECO Kit Name:  OPEN3D_E10023
     ECO Kits Superseded by This ECO Kit:  None
     ECO Kit Size:  Saveset A - 108 Blocks
                    Saveset B - 144 Blocks
                    Saveset C - 162 Blocks

             Total of 3 files - 414 Blocks

     Kit Applies To:  DEC Open3D V2.2, V2.3
                      OpenVMS Alpha V1.5, V1.5-1H1, V6.1
     System Reboot Necessary:  No


ECO KIT SUMMARY:

An ECO kit exists for DEC Open3D V2.2 and V2.3 on OpenVMS AXP V1.5
through V6.1.  This kit addresses the following problems:

  o  CPU errors logged during normal operation of a ZLX-E1 graphics
     option.  Even though the CPU error does not affect the normal
     operation of the system, the installation of this ECO kit fixes
     the problem.

IMPORTANT NOTE:  If you are running DEC Open3D for OpenVMS AXP V2.2,
                 you MUST install the OPEN3D_EO7022 (CSCPAT_2042) kit
                 BEFORE installing the OPEN3D_E10023 kit.

                 To determine what version of DEC Open3D is on the
                 system, perform a directory of SYS$HELP:*OPEN3D*.*.
                 Files listed as OPEN3D022 would signify that DEC Open3D
                 V2.2 is on the system.  OPEN3D023 would signify V2.3.


INSTALLATION NOTES:

The system/cluster does not need to be rebooted after this kit is
installed.  However, DEC Open3D should be shutdown and restarted in
order for all kit changes to take effect.

NOTE:  Please note that the actual name for the DEC Open3D ECO savesets
       is OPEN3D_E10023.  This name is different than what is documented
       in the ECO Release Notes.

Colorado Site
Georgia Site

open3d_e10023.README
open3d_e10023.CHKSUM
open3d_e10023.CVRLET_TXT
open3d_e10023.a-dcx_axpexe
open3d_e10023.b-dcx_axpexe
open3d_e10023.c-dcx_axpexe