SNALU62 SNALU62_V311 DIGITAL SNA APPC/LU6.2 V3.1 for DIGITAL UNIX ECO Summary
Copyright (c) Digital Equipment Corporation 1997. All rights reserved.
PRODUCT: DIGITAL SNA APPC/LU6.2 Programming Interface V3.1 for DIGITAL UNIX
OP/SYS: DIGITAL UNIX [R]
SOURCE: Digital Equipment Corporation
ECO INFORMATION:
ECO Kit Name: SNALU62_V311
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: 7987 Blocks (4089344 bytes)
Saveset A - 7980 Blocks (4085760 bytes)
Kit Applies To: SNA APPC/LU6.2 Programming Interface for
DIGITAL UNIX V3.1
DIGITAL UNIX V3.2C through V4.0C
System/Cluster Reboot Necessary: No
ECO KIT SUMMARY:
An ECO kit exists for DIGITAL SNA APPC/LU6.2 Programming Interface for
DIGITAL UNIX V3.1 on DIGITAL UNIX V3.2C through V4.0C. The DEC SNA LU6.2
Programming Interface Release Notes contain a complete explanation of this
release. This kit addresses the following problems:
o Use of Close option from window menu with Load/Parse and Save
Configuration
o LU-LU Session-Level Security Verification Failed
o Segmentation Faults When Session Was UNBOUND
o Virtual Memory Not Freed In CPIC When A Conversation Is In
Deallocate State
o Segmentation Faults When Trying to Free up a Buffer
o AS400 Adaptive Pacing Problem
o AS400 Fixed Pacing Problem
o Server hang if session unbound while conversation is active
o LU6.2 verbs may complete prematurely
o Unable to run server on TCP/IP hosts without a '.' in the name
o The cpic side file doesn't take the parameter security_type
o Attach manager information is missing from the configuration file
INSTALLATION NOTES:
NOTE: This is not an update kit, and the current version of the LU6.2
Product must be deleted before installing this ECO.
The ECO kit is distributed as a tar file containing the kit which can be
installed using the setld command. The tar file should be unpacked to a
suitable directory and then the setld command issued specifying that directory
as the source of the kit.
For example, if the tar file containing the kit has been copied to
/usr/tmp/snalu62310.tar:
# mkdir /usr/tmp/snalu62310
# cd /usr/tmp/snalu62310
# tar xf /usr/tmp/snalu62310.tar
# setld -l .
If the kit is delivered on tap11 then the commands would be:
# mkdir /usr/tmp/snalu62310
# cd /usr/tmp/snalu62310
# tar x
# setld -l .
Once the kit is installed, you should follow the instructions in the
installation guide's After Installation section.
[R] UNIX is a registered trademark in the United States and other
countries licensed exclusively through X/Open Company Limited
This patch can be found at any of these sites:
Colorado Site
Georgia Site
Files on this server are as follows:
snalu62_v311.README
snalu62_v311.CHKSUM
snalu62_v311.CVRLET_TXT
snalu62_v311.tar
|
