Index Index for
Section 1
Index Alphabetical
listing for U
Bottom of page Bottom of
page		 

uusend(1)


NAME

  uusend - Sends a file to a remote host


SYNOPSIS

  uusend [-m mode] local_file system1! system2! ...!remote_file

  The uusend command sends a file to a given location on a remote system.


OPTIONS

  -m mode
      Specifies that the mode of the file on the remote system be taken from
      the octal number given. If this flag is not specified, the mode of the
      input file is used.


DESCRIPTION

  The remote system does not need to be directly connected to the local
  system, but a chain of uucp links needs to connect the two system.


ENVIRONMENT VARIABLES

  The following environment variables affect the execution of uusend:

  FLWCTL
      [Tru64 UNIX]  Specifies the flow control used on the connection.
      Permitted values are: HW (hardware), SW (software), HSW (hardware and
      software), and NONE. The uugetty on the remote system must also use the
      same flow control.

  UUTIMEOUT
      Specifies the amount of time (in seconds) for uucico to try to
      establish a connection before it times out.  A value of 0 (zero)
      indicates an unlimited amount of time.


SEE ALSO

  Commands:  ct(1), cu(1), tip(1), uucico(8), uucleanup(8), uucp(1),
  uuencode(1), uulog(1), uuname(1), uupick(1), uusched(8), uustat(1),
  uuto(1), uux(1)

Index Index for
Section 1
Index Alphabetical
listing for U
Top of page Top of
page