The following sections show excerpts from
kern.log
files in
the
/var/adm/syslog.dated/date
directories:
Startup messages after running
clu_create
(Section D.1)
Startup messages after running
clu_add_member
(Section D.2)
These messages track normal cluster startup operations; therefore, in
addition to providing some level of assurance that cluster formation
and recovery operations are proceeding in an orderly fashion, they
also provide a starting point for troubleshooting cluster-related
problems.
D.1 Startup Messages After Running clu_create
Example D-1
shows a transcript of a portion
of the startup messages displayed during a reboot of the first cluster member
system after running
clu_create.
This information is also written to
/var/adm/syslog.dated/date/kern.log.
Example D-1: Startup Messages After Running clu_create
Alpha boot: available memory from 0x1506000 to 0x7f58000 Compaq Tru64 UNIX X5.1A-8 (Rev. 1747); Tue May 8 15:54:43 EDT 2001 physical memory = 128.00 megabytes. available memory = 106.32 megabytes. using 417 buffers containing 3.25 megabytes of memory Firmware revision: 5.8-10 PALcode: UNIX version 1.79-63 AlphaServer DS20 500 MHz pci1 (primary bus:1) at nexus pci2 (primary bus:1 subordinate bus:2) at pci1 slot 7 itpsa0 at pci2 slot 0 IntraServer ROM Version V2.0 (c)1998 scsi0 at itpsa0 slot 0 rad 0 itpsa1 at pci2 slot 1 IntraServer ROM Version V2.0 (c)1998 scsi1 at itpsa1 slot 0 rad 0 tu0: DECchip 21140: Revision: 2.2 tu0: auto negotiation capable device tu0 at pci2 slot 2 tu0: DEC TULIP (10/100) Ethernet Interface, hardware address: 00-06-2B-00-FC-99 tu0: auto negotiation off: selecting 10BaseT (UTP) port: half duplex pci0 (primary bus:0) at nexus isa0 at pci0 gpc0 at isa0 gpc1 not probed ace0 at isa0 ace1 at isa0 lp0 at isa0 fdi0 at isa0 fd0 at fdi0 unit 0 ata0 at pci0 slot 105 (slot 5, function 1) ata0: CYPRESS 82C693 scsi2 at ata0 slot 0 rad 0 ata1 at pci0 slot 205 (slot 5, function 2) ata1: CYPRESS 82C693 scsi3 at ata1 slot 0 rad 0 usb0 at pci0 slot 305 (slot 5, function 3) comet0: Card type 'Elsa GLoria' with 8MB framebuffer memory. comet0 at pci0 slot 7 emx0 at pci0 slot 8 KGPSA-CA : Driver Rev 1.32a : F/W Rev 3.03X2(1.11) : wwn 1000-0000-c924-4b7b emx0: Using console topology setting of : Fabric scsi4 at emx0 slot 0 rad 0 mchan0: Module revision = 34 mchan0: jumpered as HUB configuration mchan0 at pci0 slot 9 Created FRU table binary error log packet kernel console: comet0 dli: configured NetRAIN configured. i2c: Server Management Hardware Present ATM Subsystem configured with 1 restart threads ATMUNI: configured ATMSIG: 3.x (module=uni3x) configured ILMI: 3.x (module=ilmi) configured ATM IP: configured ATM LANE: configured. ATM IFMP: configured TruCluster Server X5.1A-8 (Rev. 1126); 05/08/01 04:56 clubase: configured Configuring RDG to use Memory Channel ics_hl: Configuring memory channel as transport. icsnet: configured drd configured 0 kch: configured dlm: configured Starting CFS daemons Registering CFS Services Initializing CFSREC ICS Service Registering CFSMSFS remote syscall interface Registering CMS Services TNC kproc_creator_daemon: Initialized and Ready rm primary: mchan0, hubslot = 4, phys_rail 0 (size 512 MB) rm primary: log_rail 0 (size 512 MB), phys_rail 0 (mchan0) ics_mct: icsinfo set for node 1 ics_mct: Declaring this node up 1 CNX MGR: insufficient votes to form cluster: have 1 need 2 CNX QDISK: Adding 1 quorum disk vote toward formation. CNX MGR: Cluster deli incarnation 0x7c505 has been formed CNX MGR: Founding node id is 1 csid is 0x10001 CNX MGR: membership configuration index: 1 (1 additions, 0 removals) CNX MGR: Node pepicelli 1 incarn 0x7c505 csid 0x10001 has been added to the cluster dlm: resuming lock activity kch: resuming activity CNX QDISK: Successfully claimed quorum disk, adding 1 vote. CNX MGR: quorum (re)gained, (re)starting cluster operations. Joining versw kch set. Waiting for cluster mount to complete clsm: checking for peer configurations clsm: initialized vm_swap_init: swap is set to eager allocation mode CMS: Joining deferred filesystem sets cluster alias subsystem enabled Environmental Monitoring Subsystem Configured.
See the
Cluster Administration
manual for descriptions of
information and error
messages generated by TruCluster Server.
D.2 Startup Messages After Running clu_add_member
Example D-2
shows a transcript of a portion of
the startup messages displayed during the first boot of the second cluster
member system after running
clu_add_member.
This
information is also written to
/var/adm/syslog.dated/date/kern.log.
Example D-2: Startup Messages After Running clu_add_member
Alpha boot: available memory from 0x179a000 to 0xff58000 Compaq Tru64 UNIX X5.1A-8 (Rev. 1747); Tue May 8 16:24:12 EDT 2001 physical memory = 256.00 megabytes. available memory = 231.74 megabytes. using 909 buffers containing 7.10 megabytes of memory Firmware revision: 5.8-10 PALcode: UNIX version 1.79-63 AlphaServer DS20 500 MHz pci1 (primary bus:1) at nexus pci2 (primary bus:1 subordinate bus:2) at pci1 slot 7 itpsa0 at pci2 slot 0 IntraServer ROM Version V2.0 (c)1998 scsi0 at itpsa0 slot 0 rad 0 itpsa1 at pci2 slot 1 IntraServer ROM Version V2.0 (c)1998 scsi1 at itpsa1 slot 0 rad 0 tu0: DECchip 21140: Revision: 2.2 tu0: auto negotiation capable device tu0 at pci2 slot 2 tu0: DEC TULIP (10/100) Ethernet Interface, hardware address: 00-06-2B-01-1F-5A tu0: auto negotiation off: selecting 10BaseT (UTP) port: half duplex mchan0: Module revision = 34 mchan0: jumpered as HUB configuration mchan0 at pci1 slot 8 pci0 (primary bus:0) at nexus isa0 at pci0 gpc0 at isa0 gpc1 not probed ace0 at isa0 ace1 at isa0 lp0 at isa0 fdi0 at isa0 fd0 at fdi0 unit 0 ata0 at pci0 slot 105 (slot 5, function 1) ata0: CYPRESS 82C693 scsi2 at ata0 slot 0 rad 0 ata1 at pci0 slot 205 (slot 5, function 2) ata1: CYPRESS 82C693 scsi3 at ata1 slot 0 rad 0 usb0 at pci0 slot 305 (slot 5, function 3) comet0: Card type 'Elsa GLoria' with 8MB framebuffer memory. comet0 at pci0 slot 7 emx0 at pci0 slot 9 KGPSA-CA : Driver Rev 1.32a : F/W Rev 3.02A1(1.11) : wwn 1000-0000-c922-4aac emx0: Using console topology setting of : Fabric scsi4 at emx0 slot 0 rad 0 Created FRU table binary error log packet kernel console: comet0 dli: configured NetRAIN configured. i2c: Server Management Hardware Present ATM Subsystem configured with 1 restart threads ATMUNI: configured ATMSIG: 3.x (module=uni3x) configured ILMI: 3.x (module=ilmi) configured ATM IP: configured ATM LANE: configured. ATM IFMP: configured TruCluster Server X5.1A-8 (Rev. 1126); 05/08/01 04:56 clubase: configured Configuring RDG to use Memory Channel ics_hl: Configuring memory channel as transport. icsnet: configured drd configured 0 kch: configured dlm: configured Starting CFS daemons Registering CFS Services Initializing CFSREC ICS Service Registering CFSMSFS remote syscall interface Registering CMS Services TNC kproc_creator_daemon: Initialized and Ready rm slave: mchan0, hubslot = 2, phys_rail 0 (size 512 MB) rm slave: log_rail 0 (size 512 MB), phys_rail 0 (mchan0) ics_mct: icsinfo set for node 2 ics_mct: Declaring this node up 2 ics_mct: icsinfo set for node 1 CNX MGR: Join operation complete CNX MGR: membership configuration index: 4 (3 additions, 1 removals) CNX MGR: quorum (re)gained, (re)starting cluster operations. CNX MGR: Node polishham 2 incarn 0x17396 csid 0x20002 has been added to the cluster Joining versw kch set. ics_mct: Declaring this node up 1 CNX MGR: Node pepicelli 1 incarn 0x7c505 csid 0x10001 has been added to the cluster kch: resuming activity dlm: resuming lock activity clsm: incoming CNX data: '…a^D' clsm: checking for peer configurations clsm: initialized Waiting for cluster mount to complete vm_swap_init: swap is set to eager allocation mode CMS: Joining deferred filesystem sets CNX QDISK: Successfully claimed quorum disk, adding 1 vote. cluster alias subsystem enabled Environmental Monitoring Subsystem Configured. Can't find an OSF-BASE, UNIX-WORKSTATION, or UNIX-SERVER license PAK