surface data

New Message Reply Date view Thread view Subject view Author view

Lawrence Bertoldi (lberto@sgi.com)
Fri, 04 Feb 2000 14:51:27 -0500

I have built a version of Volumizer that uses a cubic grid of evenly
spaced points
to generate images! I was wondering if anyone knows how I can build
surfaces that correspond to specific values (Isosurfaces ) in
Volumizer!

I have done this before with marching cube algorithm but wanted to see
if the facility exists in Volumizer!

By the way, Is anybody still out there, I have seen any entries since
jan 21 2000;

--
See Ya,


Lawrence Eugene Bertoldi                Technical Consultant
vnet    238-8949                        Silicon Graphics
phone   301-572-8949                    Silver Spring MD.
email   lberto@clubfed.sgi.com


~;-}>










I have built a version of Volumizer that uses a cubic grid of evenly spaced
points

to generate images! I was wondering if anyone knows how I can build

surfaces that correspond to specific values  (Isosurfaces ) in
Volumizer!

I have done this before with marching cube algorithm but wanted to see

if the facility exists in Volumizer!

 

By the way, Is anybody still out there, I have seen any entries since

jan 21 2000;

-- 
See Ya,

Lawrence Eugene Bertoldi                Technical Consultant
vnet    238-8949                        Silicon Graphics 
phone   301-572-8949                    Silver Spring MD.
email   lberto@clubfed.sgi.com

~;-}>

 

New Message Reply Date view Thread view Subject view Author view

This archive was generated by hypermail 2.0b2 on Fri Feb 04 2000 - 12:53:22 PST