Click this button to go to the index for this section.

uusend(1)
NAME
  uusend - Sends a file to a remote host

SYNOPSIS
  uusend [-m mode] local_file system1! system2! ...!remote_file

  The uusend command sends a file to a given location on a remote system.

OPTIONS
  -m mode
      Specifies that the mode of the file on the remote system be taken from
      the octal number given. If this flag is not specified, the mode of the
      input file is used.

DESCRIPTION
  The remote system does not need to be directly connected to the local
  system, but a chain of uucp links needs to connect the two system.

ENVIRONMENT VARIABLES
  The following environment variables affect the execution of uusend:

  FLWCTL
      Specifies the flow control used on the connection. Permitted values
      are: HW (hardware), SW (software), and NONE. The uugetty on the remote
      system must also use the same flow control.

  UUTIMEOUT
      Specifies the amount of time (in seconds) for uucico to try to
      establish a connection before it times out.  A value of 0 (zero)
      indicates an unlimited amount of time.

SEE ALSO
  Commands:  ct(1), cu(1), tip(1), uucico(8), uucleanup(8), uucp(1),
  uuencode(1), uulog(1), uuname(1), uupick(1), uusched(8), uustat(1),
  uuto(1), uux(1)