TITLE:              Installing a NWL Client
DOCUMENT ID:        TID1200475
DOCUMENT REVISION:  2
DATE:               06Apr95
ALERT STATUS:       Yellow
README FOR:         NA

NOVELL PRODUCT and VERSION:
NETWARE LITE V1.1

ABSTRACT:
NA

---------------------------------------------------------------------
DISCLAIMER: THE ORIGIN OF THIS INFORMATION MAY BE INTERNAL OR
EXTERNAL TO NOVELL.  NOVELL MAKES EVERY EFFORT WITHIN ITS MEAN TO
VERIFY THIS INFORMATION. HOWEVER, THE INFORMATION PROVIDED IN THIS
DOCUMENT IS FOR YOUR INFORMATION ONLY. NOVELL MAKES NO EXPLICIT OR
IMPLIED CLAIMS TO THE VALIDITY OF THIS INFORMATION.
---------------------------------------------------------------------

ISSUE:

INSTALLING A NETWARE LITE CLIENT

To install NetWare Lite and configure your computer as a client, do
the following steps. Depending on your current setup, the
installation program may skip some of the steps.

1.   Insert the diskette labeled PROGRAM into the A: (or B:) drive.

2.   Type A:INSTALL, and press <Enter>.

3.   Verify that "Make this machine a client" is highlighted, and
press <Enter>.

4.   Type in the path of the directory where you want NetWare Lite
installed, or simply press <Enter> to accept the default. You may
include the A: or B: drive letter if your computer does not have a
hard disk installed. See document 1200469 on Novell's FaxBack Service
or TID1200469 from the NSE Pro or Compuserve for more information on
installing to a floppy diskette.

5.   Insert the diskette labeled DRIVER into the A: drive, and press
<Esc>.

6.   Use the arrow keys to highlight the type of network board in
your machine, and press <Enter>. If you are not sure which board to
choose, refer to the hardware documentation to determine what type of
board you have or which interface it is compatible with.

7.   A window showing default settings for your board is displayed.
You may change these if necessary by highlighting the item and
pressing <Enter>, then highlight the correct value and press <Enter>.
Refer to the hardware documentation if you are not sure what the
settings should be. When the settings are correct, press <Esc>.

8.   Answer YES or NO to the "path" message. Note that if the
C:\NWLITE directory is not in the DOS path, you will have to CD to it
to use the NET utility. You will also have to include the path for
every NET command executed at the command line.

9.   Answer YES or NO to the "lastdrive" message. Note that LASTDRIVE
should be set to the G: drive or higher to use the NET utility. If
you answer NO, you must edit the CONFIG.SYS file to include a
LASTDRIVE command and reboot before you can use any NET command.

10.  NetWare Lite is now installed. Press <Esc> to exit the
installation program.

---------------------------------------------------------------------
Any trademarks referenced in this document are the property of their
respective owners. Consult your product manuals for complete
trademark information.
---------------------------------------------------------------------