TITLE:              Installing a NWL Client and Server
DOCUMENT ID:        TID1200472
DOCUMENT REVISION:  1
DATE:               31MAR95
ALERT STATUS:       Yellow
README FOR:         NA

NOVELL PRODUCT and VERSION:
NETWARE LITE V1.1

ABSTRACT:
NA

---------------------------------------------------------------------
DISCLAIMER: THE ORIGIN OF THIS INFORMATION MAY BE INTERNAL OR
EXTERNAL TO NOVELL.  NOVELL MAKES EVERY EFFORT WITHIN ITS MEAN TO
VERIFY THIS INFORMATION. HOWEVER, THE INFORMATION PROVIDED IN THIS
DOCUMENT IS FOR YOUR INFORMATION ONLY. NOVELL MAKES NO EXPLICIT OR
IMPLIED CLAIMS TO THE VALIDITY OF THIS INFORMATION.
---------------------------------------------------------------------

ISSUE:

INSTALLING A NETWARE LITE CLIENT AND SERVER

The computer you are installing NetWare Lite on must have a hard disk
to be configured as a server. Do not simply copy the files off the
original (or backup) diskettes. To install NetWare Lite and configure
the computer as both server and client, perform the following steps.
Depending on your current setup, the installation program may skip
some of the steps.

1.   Insert the diskette labeled PROGRAM into the A: (or B:) drive.

2.   Type A:INSTALL, and press <Enter>.

3.   Use the arrow keys to highlight "Make this machine a client and
a server," and press <Enter>.

4.   Type in a name for the server, and press <Enter>.

5.   FILES must be set in the CONFIG.SYS file for the server to run.
The default value shown should work in most situations. If you know
that you need to use different value, answer NO to the "files"
message and edit CONFIG.SYS appropriately.

6.   BUFFERS must be set in the CONFIG.SYS file for the server to
run. The default value shown should work in most situations. If you
know that you need to use a different value, answer NO to the
"buffers" message and edit CONFIG.SYS appropriately.

7.   Insert the diskette labeled DRIVER into the A: drive, and press
<Esc>.

8.   Use the arrow keys to highlight the type of network board in
your machine, and press <Enter>. If you are not sure which board to
choose, refer to the hardware documentation to determine what type of
board you have or which interface it is compatible with.

9.   A window showing default settings for your board is displayed.
You may change these if necessary by highlighting the item and
pressing <Enter>, then highlight the correct value, and press
<Enter>. Refer to the hardware documentation if you are not sure what
the settings should be. When the settings are correct, press <Esc>.

10.  Answer YES or NO to the "path" message. Note that if the
C:\NWLITE directory is not in the DOS path, you will have to CD to it
to use the NET utility. You will also have to include the path for
every NET command executed at the command line.

11.  Answer YES or NO to the "lastdrive" message. Note that LASTDRIVE
should be set to the G: drive or higher to use the NET utility. If
you answer NO, you must edit the CONFIG.SYS file to include a
LASTDRIVE command and reboot before you can use any net command.

12.  NetWare Lite is now installed. Press <Esc> to exit the
installation program.

---------------------------------------------------------------------
Any trademarks referenced in this document are the property of their
respective owners. Consult your product manuals for complete
trademark information.
---------------------------------------------------------------------