AutoYaST: Automatic Linux Installation and Configuration with YaST2 | ||
---|---|---|
<<< Previous | Chapter 4. Configuration and Installation Options | Next >>> |
With the run-level resource you can set the default run-level and specify in detail which system services you want to be started in which run-level.
The default property specifies the default run level of the system. Changes to the default run-level will take effect the next time you boot the system. After installation is completed, the system has run-level 5, which is Full multiuser with network and XDM. If you have configured a system with no X11, then it is recommended to reboot the system after the first stage using the reboot property in the general resource.
A service should run in using a space delimited list of the run-levels as shown in the following example. An alternative to specifying the exact run-levels is to change the status of the service by either enabling or disabling it using the service_status property.
Example 4-22. Run-level Configuration
<configure> .... <runlevels> <default>3</default> <services config:type="list" > <service> <service_name>at</service_name> <service_start>3 5</service_start> </service> <service> <service_name>portmap</service_name> <service_status>enable</service_status> </service> <service> <service_name>hwscan</service_name> <service_status>disable</service_status> </service> </services> </runlevels> .... </configure> |
<<< Previous | Home | Next >>> |
Software | Up | Network configuration |