NOVELL TECHNICAL INFORMATION DOCUMENT

DOCUMENT PROCESSING INFO:  THIS DOCUMENT REPLACES FYI.M.1108
TITLE:  PRIMARY PARTITION TOO SMALL TO INSTALL DR DOS
DOCUMENT ID:  TID800031
DOCUMENT REVISION:  A
DATE:  16AUG94
AUTHOR:  ACKEELE;KBANTA
ALERT STATUS:  Yellow
DISTRIBUTION:  Public
INFORMATION TYPE:  Symptom Solution
README FOR:  NA
NOVELL PRODUCT CLASS:

Desktop Products

NOVELL PRODUCT and VERSION:

DR DOS 6.0

CATEGORY:

Installation

ABSTRACT:

NA

-----------------------------------------------------------------
DISCLAIMER
THE ORIGIN OF THIS INFORMATION MAY BE INTERNAL OR EXTERNAL TO NOVELL. 
NOVELL MAKES EVERY EFFORT WITHIN ITS MEANS TO VERIFY THIS INFORMATION. 
HOWEVER, THE INFORMATION PROVIDED IN THIS DOCUMENT IS FOR YOUR INFORMATION
ONLY.  NOVELL MAKES NO EXPLICIT OR IMPLIED CLAIMS TO THE VALIDITY OF THIS
INFORMATION.
-----------------------------------------------------------------

SYMPTOM

DR DOS WILL NOT INSTALL IF THE PRIMARY PARTITION IS TOO SMALL.

ISSUE/PROBLEM

If the primary partition is less than 2.5 MB (Megabytes) DR DOS will not
install.  If Security is enabled during installation, FDISK cannot correct
this situation because of the secure disk.  Installation will not
complete, but security will be installed.

SOLUTION

Follow the procedures outlined below.

1.   Boot from the original DR DOS 6 installation diskette
2.   Press F10 to abort and exit to DOS
3.   From the A: Prompt, type SYS C:\  This command makes the
     hard disk bootable
4.   Copy the following files to the root directory of C:
          LOGIN.EXE           CONFIG.SYS
          AUTOEXEC.BAT        SSTORDRV.SYS        DEVSWAP.COM


5.   Copy the following files to the DRDOS directory on C:
          INSTALL.EXE         FDISK.COM

6.   Rename C:\INSTALL.EXE to C:\SETUP.EXE
7.   Remove the floppy from drive A: and reboot the computer
8.   Enter the Master password
9.   At the C: prompt, type SETUP
10.  Select only the SECURITY option
11.  Enable SECURITY and enter a different password for the
     MASTER PASSWORD and the USER PASSWORD
12.  Complete the installation and exit to DOS
13.  Run SETUP again
14.  Disable SECURITY, complete the installation and exit to DOS
15.  Type FDISK and remove all partitions on the hard drive
16.  Create a primary partition of at least 3MB in size
     (recommended- 10MB)
17.  Reboot with the original installation diskette and complete
     the installation process.

-----------------------------------------------------------------
Any trademarks referenced in this document are the property of their
respective owners.  Consult your product manuals for complete trademark
information.
-----------------------------------------------------------------