DOCUMENT:Q106141  17-DEC-2000  [msdos]
TITLE   :FORMAT and DISKCOPY Errors with Stacker 3.x
PRODUCT :Microsoft Disk Operating System
PROD/VER:MS-DOS:3.2,3.3,4.x,5.0,5.0a,6.0,6.2,6.21,6.22
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft MS-DOS operating system versions 3.2, 3.3, 4.0, 4.0a, 5.0, 5.0a, 6.0, 6.2, 6.21, 6.22 
-------------------------------------------------------------------------------

SYMPTOMS
========

If you are running STAC Electronics Stacker version 3.0 or 3.1 on your computer,
you may receive the following errors when you use the MS-DOS DISKCOPY and FORMAT
commands on floppy disks:

With DISKCOPY:

   Formatting while copying
   Drive types or diskette types not compatible
   Copy process ended
   Copy another diskette (Y/N)?

With FORMAT:

   Existing format differs from that specified
   This disk cannot be unformatted.
   Proceed with format (Y,N)?

   -or-

   Parameter not compatible with fixed disk.
   Format terminated.

   -or-

   Error reading partition table. Format terminated.

   -or-

   Extended error 21. Format terminated.

CAUSE
=====

According to STAC Electronics, these problems are caused by Stacker's AutoMount
feature. If you remove a Stacker-compressed floppy disk and insert an
uncompressed disk in the same drive, you may be unable to use the MS-DOS
DISKCOPY and FORMAT commands on the uncompressed disk until the drive is
unmounted. In addition, a Stacker-compressed disk must first be unmounted before
it can be formatted with the MS-DOS FORMAT command.

WORKAROUND
==========

To work around these problems, first unmount the disk drive. This can be done by
typing "stacker -x:" (without the quotation marks) at the MS-DOS command prompt
(where <x> is the letter of the floppy disk drive) or by removing the
compressed floppy disk from the drive and rebooting the computer.

MORE INFORMATION
================

Stacker 3.0 and 3.1 are manufactured by STAC Electronics, a vendor independent
of Microsoft; we make no warranty, implied or otherwise, regarding these
products' performance or reliability.

REFERENCES
==========

"Stacker 3.0 for Windows and DOS User's Guide," pages 137 and 274


Additional query words: 6.22 6.00 6.20 6.21 6.0 6 msdos format.com diskcopy.com error message 3rdparty stacked

======================================================================
Keywords          :  
Technology        : kbMSDOSSearch kbMSDOS400 kbMSDOS320 kbMSDOS621 kbMSDOS622 kbMSDOS620 kbMSDOS600 kbMSDOS500 kbMSDOS330 kbMSDOS500a
Version           : MS-DOS:3.2,3.3,4.x,5.0,5.0a,6.0,6.2,6.21,6.22

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 2000.