MemMaker Err Msg: Invalid Session ID (97607)


The information in this article applies to:

  • Microsoft MS-DOS operating system 6.0
  • Microsoft MS-DOS operating system 6.2
  • Microsoft MS-DOS operating system 6.21
  • Microsoft MS-DOS operating system 6.22
This article was previously published under Q97607

SYMPTOMS

You may receive the following error message when you run MemMaker if there is more than one MEMMAKER.STS file on your hard drive:
Invalid Session ID

WORKAROUND

To work around this problem:

  1. Delete all the MEMMAKER.STS files.
  2. Remove any MemMaker commands from the CONFIG.SYS and AUTOEXEC.BAT files.
  3. Run MemMaker again.
If you are using disk compression, you may need to run MemMaker with the /SWAP parameter.

MORE INFORMATION

The "Invalid Session ID" error message means the identifier that is passed to MEMMAKER, CHKSTATE, or SIZER is not the same as the identifier in the MEMMAKER.STS file. An "Invalid Session ID" indicates that an incorrect .STS file is being found.
Modification Type:MajorLast Reviewed:11/22/1999
Keywords:KB97607
©2002 Microsoft Corporation. All rights reserved.