ACC: Raised and Sunken Check Box and Option Button Controls (96896)


The information in this article applies to:

  • Microsoft Access 1.0
  • Microsoft Access 1.1
  • Microsoft Access 2.0
This article was previously published under Q96896
Novice: Requires knowledge of the user interface on single-user computers.

SYMPTOMS

In VGA resolution (640 X 480) raised check boxes and option buttons are indistinguishable from sunken check boxes and option buttons on both forms and reports.

STATUS

This behavior is by design.

MORE INFORMATION

You can specify three different appearances for controls on your forms and reports: Normal, Raised, and Sunken. Check box controls and option button controls allow you to specify these different appearances, but raised and sunken are displayed identically.

Steps to Reproduce Behavior


  1. Create a blank unbound form in VGA resolution.
  2. In Design view, add three check box controls to the form.
  3. Add three option button controls to the form.
  4. Choose the Palette button and make one of the check boxes and one of the option buttons sunken. Leave one of each normal. Make one of each raised.
  5. Switch to Form view. Compare the raised controls to the sunken controls. Note that the raised check boxes and option buttons are indistinguishable from sunken check boxes and option buttons.

REFERENCES

Microsoft Access "User's Guide," version 1.0, Chapter 12, "Using Special Design Effects on Forms and Reports," page 306
Modification Type:MajorLast Reviewed:5/9/2003
Keywords:kbprb kbusage KB96896
©2002 Microsoft Corporation. All rights reserved.