Troubleshooting TCP/IP Utilities for LAN Manager (96681)

MORE INFORMATION

Verify IP Layer Connectivity with "ping [ipaddr]"

All of the TCP/IP services rely on the ability of the IP layer to transfer datagrams between machines. The test of IP layer connectivity is the "ping" command.

You can execute "Ping" several different ways. The most basic way is "ping x.x.x.x" where x.x.x.x is the IP address of the target machine. Here is a description of what occurs when you do this: If [the network portion of the target IP address equals the network portion of the IP address of the local machine]:

• ARP (Address Resolution Protocol) is used to determine the MAC address of the target machine from the given IP address. If previous contact has been made with the target machine, ARP may supply the MAC address from cache. If not, an ARP broadcast is sent out on the wire, requesting that the target machine supply its MAC address.
• An ICMP echo request is sent to the target machine.
  
  Else
• ARP is used to determine the MAC address of the default gateway (router) instead of the target node. Again, if the IP<->MAC address mapping is available from cache, no ARP goes out onto the wire. If not, then an ARP broadcast is sent, requesting the MAC address of the default gateway. Once the MAC address of the router has been determined:
• An ICMP echo request is sent as follows:
  
  
  • destination MAC address = router MAC address
  • destination IP address = target node IP address
  The router then picks the frame up off the wire, looks at the network portion of the destination IP address, and forwards the packet as necessary. When the packet arrives at a router that is directly connected to the destination network, that router must resolve the destination IP address to the MAC address of the target node, again using the ARP mechanism.
  
  When the target node receives a "ping", it must respond with an "ICMP echo response". The mechanism for getting the response back to the originating machine is the same as that described above.
  
  Note that ping can be used as a loopback mechanism to test the local machine. When this is done the ICMP echo request doesn't actually go out on the wire. If a machine can't ping itself, then there is a software or hardware installation problem.

Verify Name-to-IP Address Resolution

Most people prefer to use a name rather than an IP address to specify a destination machine. This means that the network software must be able to translate names to IP addresses. There are two means for doing this:

Test the Specific Utilities

Each utility is different, but once IP connectivity has been established they can be tested individually.

FTP: Type ftp ipaddr or ftp hostname. Microsoft does not currently provide an ftp server, so the destination address or name must be another system that provides the ftp service. See chapter three of the "Microsoft LAN Manager User's Guide" for specific options.

TELNET: Telnet is accessed differently on MS-DOS and OS/2 machines. From MS-DOS, type kermit ipaddr or kermit hostname. From OS/2, type tty ipaddr or tty hostname. See chapter 2 of the "Microsoft LAN Manager User's Guide" for specific options. If you choose, you can use a more sophisticated terminal emulator than Kermit or tty, in which case you should specify BAPI as the network interface in the emulator setup. Any emulator which supports the BAPI interface should work with Microsoft telnet.

RSH: The key to making RSH (and RCP) work properly is to set permissions correctly on the target machine. Chapter five of the "Microsoft LAN Manager User's Guide" describes this setup in detail. Note in particular that the target host must be able to resolve the IP address to a hostname in order for security to pass. This means that your IP address must be available to the target host either from the Domain Name Server, or from its hosts file. The syntax for RSH is "rsh hostname command."

RCP: As with RSH, passing security is the most difficult part of setup. For RCP to succeed, you must have the appropriate permissions on both the source and the destination machines. The syntax for RCP is: