Intersvr Resets Screen Mode (95959)


The information in this article applies to:

  • Microsoft MS-DOS operating system 6.0
  • Microsoft MS-DOS operating system 6.2
  • Microsoft MS-DOS operating system 6.21
  • Microsoft MS-DOS operating system 6.22
This article was previously published under Q95959

SUMMARY

Intersvr resets the screen to 25-line mode and may not display information on the lower part of the screen when you are loading XANSI.SYS and using an Orchid ProDesigner IIs in 80-characters-per line/60-lines-per-screen mode. There is no work around at this time.

This problem does not occur with ANSI.SYS and MODE.COM when they are used with the video modes they support.

MORE INFORMATION

For more information on MODE and video support, type the following at the MS-DOS command prompt and press ENTER:

help mode (set display mode)

Intersvr is a component of the MS-DOS file transfer utility Interlnk. For more information on Interlnk, type the following command at the MS-DOS command prompt or see Chapter 7, "Features for Your Laptop Computer," in the "MS-DOS 6 User's Guide":

help interlnk

The products included here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.
Modification Type:MajorLast Reviewed:11/26/1999
Keywords:KB95959
©2002 Microsoft Corporation. All rights reserved.