ACC: "Not Enough Memory to Run SETUP.EXE" Error Message (94928)
The information in this article applies to:
- Microsoft Access 1.0
- Microsoft Access 1.1
- Microsoft Access 2.0
This article was previously published under Q94928 Novice: Requires knowledge of the user interface on single-user computers.
SYMPTOMS
When you try to run the Microsoft Access Setup program, it fails and you
receive one of the following out-of-memory error messages:
Insufficient Memory
-or-
Not enough memory to run SETUP.EXE
When this error occurs, you know you have sufficient space on the disk you
are installing Microsoft Access to and your AUTOEXEC.BAT file contains a
valid SET TEMP statement that specifies a directory that has free disk
space.
CAUSE
One cause of this error relates to an incorrect CMOS setting for the floppy
disk drive from which Microsoft Access is installed.
RESOLUTION
Modify the CMOS setting to correctly configure the disk drive. If you need
assistance to change the settings appropriately, contact your dealer or
hardware manufacturer.
MORE INFORMATION
The error messages above can occur when you install Microsoft Access
from a 1.2-megabyte disk drive and the CMOS setting for that drive
indicates that it is a 360-kilobyte disk drive.
| Modification Type: | Major | Last Reviewed: | 5/9/2003 |
|---|
| Keywords: | kberrmsg kbprb kbsetup KB94928 |
|---|
|