Printing Problems at DOS after Using the OKI24.DRV in Windows (94165)
The information in this article applies to:
- Microsoft Windows 3.1
- Microsoft Windows 3.11
This article was previously published under Q94165 SYMPTOMS
After you print in either mode of Windows using the Okidata 24-pin driver
(OKI24.DRV), you may have problems printing from an MS-DOS command prompt
or from MS-DOS-based application in Windows.
These problems include:
- All MS-DOS printing is triple-spaced on an Okidata ML 393 after
printing in Windows
- All MS-DOS printing has extremely small line feeds, and an entire
page prints in only a few lines on an Okidata ML 393 Plus after
printing in Windows.
CAUSE
The problems occur with the OKI24.DRV version 1.0 dated 3/10/92 that
ships with Windows 3.1. The Windows driver does not appear to be properly
resetting the printer after use.
RESOLUTION
Microsoft is researching this problem and will post new information
here as it becomes available.
Modification Type: | Major | Last Reviewed: | 10/13/2003 |
---|
Keywords: | KB94165 |
---|
|