WFWG Err Msg: Parameter Format Not Correct (92875)


The information in this article applies to:

  • Microsoft Windows for Workgroups 3.1
This article was previously published under Q92875

SYMPTOMS

After you load the NDIS driver for the Thomas Conrad TC6145 card, WORKGRP.SYS may report the following error message:
Parameter Format Not Correct

WORKAROUND

This card may have "compatibility mode." If so, configure the card for compatibility with a card listed in Setup or the Network section of Control Panel.

STATUS

The TC6145 is an older card and is no longer supported by Thomas Conrad. The TC6242 card does not have this problem.
Modification Type:MajorLast Reviewed:10/27/1999
Keywords:KB92875
©2002 Microsoft Corporation. All rights reserved.