WFWG Fails with 3Com Etherlink Plus (3C505) (92789)
The information in this article applies to:
- Microsoft Windows for Workgroups 3.1
This article was previously published under Q92789 SUMMARY
Windows for Workgroups does not detect the direct memory access (DMA)
channel used by the Etherlink Plus card. To set up the DMA channel for
Etherlink, use the Windows Control Panel to manually set the DMA
channel during or after installation.
MORE INFORMATION
By default, the Windows for Workgroups Setup program sets the DMA to
channel 1, which is the factory default for this card. However, since
3Com recommends DMA channels 5, 6, or 7 for a 16-bit slot (the most
common) this setting may not be correct for your card. Therefore, if
you have the Etherlink Plus card in a 16-bit slot and have changed
your DMA channel to 5, 6, or 7, you must run Control Panel and adjust
the DMA Channel setting.
Modification Type: | Major | Last Reviewed: | 10/28/1999 |
---|
Keywords: | KB92789 |
---|
|