Using Calcomp Drawing Board/Pad Series II with Windows 3.1 (90568)


The information in this article applies to:

  • Microsoft Windows 3.1
  • Microsoft Windows 3.11
This article was previously published under Q90568

SYMPTOMS

Calcomp Drawing Pad or Drawing Board Series II Setup program may produce the following error when you try to install drivers in Windows 3.1:
Cannot find SETUP.INF.

CAUSE

Calcomp technical support has confirmed that the Calcomp Drawing Pad or Drawing Board Series II graphics tablets require driver setup version 1.5 or later to work properly with Windows 3.1.

The error message indicates that the version of the installation program is earlier than 1.5 and was designed for Windows 3.0. According to Calcomp technical support, version 1.5 allows the successful installation of the drivers in Windows 3.1. The version number can be found on the Calcomp driver installation disk label.

WORKAROUND

To work around this problem contact for an updated driver installation disk.

The Calcomp products included here are manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.
Modification Type:MajorLast Reviewed:10/10/2003
Keywords:KB90568
©2003 Microsoft Corporation. All rights reserved.