Windows Err Msg: Failed to Register Server (85326)
The information in this article applies to:
- Microsoft Windows 3.1
- Microsoft Windows 3.11
- Microsoft Windows for Workgroups 3.1
- Microsoft Windows for Workgroups 3.11
This article was previously published under Q85326 SYMPTOMS
If you are installing software and/or updating the REG.DAT file using
Registration Editor (REGEDIT.EXE) under Windows version 3.1, you may
receive the following error message:
Failed to Register Server
CAUSE
This error can be caused by any of the following:
- Two REG.DAT files on your hard drive
- A corrupt REG.DAT file
- A write-protected REG.DAT file
RESOLUTION
To correct this problem,
- Check to see if there are two REG.DAT files on your hard drive. (If
there are two files, one file is probably in the WINDOWS directory,
while the other is likely in the WINDOWS\SYSTEM directory.)
There should only be one copy of these files on your hard drive; it
should be in the WINDOWS directory. If there is a REG.DAT file in
your WINDOWS\SYSTEM directory, delete the REG.DAT file in your
WINDOWS\SYSTEM directory.
- If there aren't two REG.DAT files on your hard drive, the REG.DAT
file is probably corrupt or write-protected. (REGEDIT /U cannot
correct the file.) Delete the file, then run REGEDIT.EXE to
re-create the REG.DAT file.
| Modification Type: | Major | Last Reviewed: | 11/26/2003 |
|---|
| Keywords: | KB85326 |
|---|
|