You receive a "URI already used" error message in BizTalk Server 2004 Explorer when you create a send port that uses the EDI Transport type (837266)


The information in this article applies to:

  • Microsoft BizTalk Server 2004 Developer Edition
  • Microsoft BizTalk Server 2004 Enterprise Edition
  • Microsoft BizTalk Server 2004 Partner Edition
  • Microsoft BizTalk Server 2004 Standard Edition

SYMPTOMS

When you create a send port in Microsoft BizTalk Server 2004 Explorer that uses the Electronic Data Interchange (EDI) Transport type, you may receive an error message that is similar to the following:
EDI Custom Editor
URI already used.
"SendPort"
Note In this error message, SendPort is a placeholder for the actual name of the send port that is used.

CAUSE

This behavior occurs because you cannot have multiple send ports that are configured to use the same EDI address.

RESOLUTION

To resolve this behavior, configure the logical address of the send port to reference an EDI address that is not being used by another send port.

STATUS

This behavior is by design.
Modification Type:MinorLast Reviewed:9/28/2004
Keywords:kbtshoot kbprb KB837266 kbAudDeveloper
©2004 Microsoft Corporation. All rights reserved.