"File not found" error message when you try to use a saved network settings file to configure your Microsoft Broadband Networking hardware (836518)


The information in this article applies to:

  • Microsoft Broadband Network Utility
  • Microsoft Broadband Networking 10 100 Ethernet 5 Port Switch MN150
  • Microsoft Broadband Networking 10 100 Ethernet Notebook Adapter MN120
  • Microsoft Broadband Networking 10 100 Ethernet PCI Adapter MN130
  • Microsoft Broadband Networking 10 100 Ethernet USB Adapter MN110
  • Microsoft Broadband Networking 10 100 Ethernet Wired Base Station MN100
  • Microsoft Broadband Networking Wireless Base Station MN500
  • Microsoft Broadband Networking Wireless Base Station MN-700
  • Microsoft Broadband Networking Wireless Desktop Kit MN610
  • Microsoft Broadband Networking Wireless Notebook Adapter MN520
  • Microsoft Broadband Networking Wireless Notebook Adapter MN-720
  • Microsoft Broadband Networking Wireless Notebook Kit MN620
  • Microsoft Broadband Networking Wireless Notebook Kit MN-820
  • Microsoft Broadband Networking Wireless PCI Adapter MN-730
  • Microsoft Broadband Networking Wireless USB 2.0 Adapter MN-710
  • Microsoft Broadband Networking Wireless USB Adapter MN510

SYMPTOMS

When you try to configure your Microsoft Broadband Networking hardware by using a saved network settings file, you may receive the following error message:
File not found

CAUSE

This issue may occur if you change the file name from the default file name "Networksettings.xml".

RESOLUTION

To resolve this issue, do not click My settings are on a floppy on the Where are your network settings located? page in the Microsoft Broadband Networking Setup Wizard. Instead, click My settings are in a file available from this computer, locate the floppy disk drive, and then click your configuration file.
Modification Type:MajorLast Reviewed:3/5/2004
Keywords:kbHardware kberrmsg kbprb KB836518
©2004 Microsoft Corporation. All rights reserved.