Windows 3.1 Setup Error Codes (S208 through S214) (82771)

SUMMARY

When a Setup error message contains an error code, it also includes some text indicating what Setup was trying to do, for example, copying a file. The text of the error message indicates whether the error is fatal or not. In some nonfatal cases, Setup may be performing an operation (such as copying a file) that is needed to run Microsoft Windows. Other times the error may prevent some specific feature of Windows from operating properly.

In many cases, the error code is an MS-DOS extended error code. These error codes are between 0 and 100. Setup-specific error codes have two different formats, depending on whether the error occurs during the character (MS- DOS) mode or the Windows graphical user interface (GUI) mode portion of Setup. The character mode Setup-specific error numbers are in the format "Snnn", where "nnn" is any three-digit number. The GUI mode error numbers are codes greater than 200.

MORE INFORMATION

GUI Mode Setup Error Codes

208

Out of disk space during file copy in VerInstallFile. Because of the disk space checks that Setup does, this problem should occur only if you have upgraded over an invalid Windows installation (that is, files have been deleted manually). Make sure there is enough disk space and then run Setup again. Also make sure that VER.DLL does not exist in the WINDOWS directory. It should only be in the WINDOWS\SYSTEM directory.

209

File in use. This error occurs if some file that needs to be replaced by Setup is in use or opened by another some other software. Make sure Setup is the only application running or exit Windows and run Setup from the MS-DOS prompt.

210

Destination file is write-protected. Type

ATTRIB -r <filename>

at the MS-DOS prompt, where <filename> is the indicated file and run Setup again. This problem may also be caused by virus- protection software, in which case, this software should be disabled while running Setup.

211

Buffers allocated for file expansion operations are too small. This error should never occur. If it does, free up some memory and run Setup again.

212

Unknown version mismatch happened during attempt to install file. This problem can be caused by the incorrect version of VER.DLL running or by corrupt files. Make sure you do not have VER.DLL in your WINDOWS directory. It should only be in the WINDOWS\SYSTEM directory.

213

File expansion initialization failed. This problem is probably due to insufficient memory.

214

Source file is unreadable. This problem is probably due to drive hardware problems, corrupt files or disks, or, if you are setting up from a network, network problems. Setup error 214 can also be caused by incorrect CMOS settings for floppy drives or third party extended memory managers.