Auto "Top Of Form" Not Supported on Okidata Printers (82526)
The information in this article applies to:
- Microsoft Windows 3.0
- Microsoft Windows 3.1
- Microsoft Windows 3.11
This article was previously published under Q82526 SUMMARY
The automatic "Top Of Form" adjustment for the Okidata 9- and 24-pin
dot-matrix printers is not supported under the Microsoft Windows. The
paper must be adjusted so that the top of the page or perforation is right
above the print head.
MORE INFORMATION
The Okidata 9- and 24-pin printers provide an automatic Top Of Form
adjustment. To make this adjustment, load in the tractor-feed paper so
that the paper is just grabbing on a few of the pins. Then pull back
the lever on the left towards the front of the printer; this process
should automatically feed the paper to the correct position. Push the
lever towards the back of the printer. The printer knows that the
print head is about 7/8-inch down from the top of the page; however,
Windows needs it right at the top.
The products included here are manufactured by vendors independent of
Microsoft; we make no warranty, implied or otherwise, regarding these
products' performance or reliability.
| Modification Type: | Minor | Last Reviewed: | 7/7/2005 |
|---|
| Keywords: | KB82526 |
|---|
|