PaintJet Printer Fonts Included with Windows (75894)


The information in this article applies to:

  • Microsoft Windows 3.0
  • Microsoft Windows 3.0a
This article was previously published under Q75894

SUMMARY

There are three specific font files, .PJFs, for the HP PaintJet printer included with the Microsoft Windows version 3.0 and 3.0a Setup disks. The names of each of the files are listed below:
  • CR124PA.PJF
  • LG08RPA.PJF
  • LG12RPA.PJF

MORE INFORMATION

The location of these files depends on the version of Windows (3.0 or 3.0a) and the size of the Setup disks being used. Use the following chart to pinpoint their location. 
Windows Version   Disk Size        Disk #
-----------------------------------------------
   3.00           [5.25\1.2MB]     Disk #5
   3.00           [3.5\720K]       Disk #7
   3.00           [5.25\360K]      Disk #12
   3.00a          [5.25\1.2MB]     Disk #5
   3.00a          [3.5\720K]       Disk #5
   3.00a          [3.5\720K]       Disk #6

CR12RPA.PJF, LG08RPA.PJF, LG12RPA.PJF

PJFs are PaintJet Fonts for the PaintJet driver that Zenographics wrote for Microsoft. They can be installed by using the Windows Control Panel using the font installer. The installation steps listed below will provide assistance in the configuration of these printer fonts.

Steps to Install PaintJet Fonts

  1. Run the Control Panel.
  2. Select the Printers icon from the Control Panel.
  3. Double-click the PaintJet driver in the listing of Install Printers to make it active or install the driver and then choose Active from the Status Box.
  4. Choose the Configure button on the right-hand side.
  5. Choose the Setup button from the Printers Configure dialog box.
  6. Choose the Fonts button from the HP PaintJet Setup dialog box.
  7. Choose the Add button and choose the desired fonts to be installed.
  8. Choose OK.
Modification Type:MinorLast Reviewed:7/7/2005
Keywords:KB75894
©2004 Microsoft Corporation. All rights reserved.