Zenith Multiboot Option and MS-DOS 5.0 (75192)


The information in this article applies to:

  • Microsoft MS-DOS operating system 5.0
  • Microsoft MS-DOS operating system 5.0a
This article was previously published under Q75192

SUMMARY

The setup/diagnostic shell built into ROM on Zenith computers normally allows you to select several different drives as the boot drive. Under MS-DOS 5.0, the only options that will work are the first hard disk (C) and the first floppy drive (A).

MORE INFORMATION

The setup/diagnostic shell is invoked on some Zenith computers by pressing the CTRL+ALT+INSERT key combination. This shell will accept a number of commands, one of them being the command that switches the boot drive. The normal syntax of this command is as follows:

B [{F|W}][{0|1|2|3}][:<partition>]

where

F = Floppy
W = Winchester (hard drive)
0 = the first drive
1 = the second drive, and so on

For example, BW0 means boot from the first hard disk (C), and BF1 means boot from the second floppy (B). By design, MS-DOS 5.0 can only boot from the first hard drive (C) and the first floppy drive (A). Consequently, the only valid options under MS-DOS 5 are BW0 and BF0.

The product included here is manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.
Modification Type:MajorLast Reviewed:9/30/2003
Keywords:KB75192
©2003 Microsoft Corporation. All rights reserved.