Using the RESTORE Command to View Backup Files (75037)


The information in this article applies to:

  • Microsoft MS-DOS operating system 5.0
This article was previously published under Q75037

SUMMARY

The Microsoft MS-DOS version 5.0 RESTORE command allows you to view files that have been backed up with the MS-DOS version 5.0 BACKUP command.

NOTE: If the command reports that no files are found, add the /s parameter to include subdirectories.

MORE INFORMATION

When a directory listing command is issued on a backup floppy disk, the only information reported is as follows: 
    Volume in drive X is BACKUP XXX
   Volume Serial Number is XXXX-XXXX
   Directory of X:\ 

   Backup 001     <filesize> <date> <time>
   Control 001    <filesize> <date> <time>
           2 file(s)  <total> bytes
                      <total> bytes free
To view the individual files on a backup floppy disk, use the following command and syntax:

restore a: c: /d

NOTE: This is the correct syntax for the command. On page 144 of the "Microsoft MS-DOS User's Guide and Reference" for version 5.0, the command syntax is incorrectly stated as: "restore c: a: /d."

The RESTORE command displays only the files found on the backup disk's root directory. If no files are found in the root directory of the backup disk, the message "ERROR! No files were found to restore" is displayed.

To view all the files on a backup disk, you should add the /s parameter to the restore command to view files (for example, RESTORE A: C: /D /S). This also lists all the files in the root and subdirectories on the backup disk.

For more information, see page 144 of the version 5.0 "Microsoft MS-DOS User's Guide and Reference."
Modification Type:MajorLast Reviewed:11/22/1999
Keywords:KB75037
©2002 Microsoft Corporation. All rights reserved.