Corruption of the SETVER Table (74765)
The information in this article applies to:
- Microsoft MS-DOS operating system 5.0
- Microsoft MS-DOS operating system 5.0a
- Microsoft MS-DOS operating system 6.0
- Microsoft MS-DOS operating system 6.2
- Microsoft MS-DOS operating system 6.21
- Microsoft MS-DOS operating system 6.22
This article was previously published under Q74765 SUMMARY
You can use the MS-DOS SETVER.EXE program to report a version number
of MS-DOS that is different than the current version to programs that
do a version check. This allows some programs to run in your installed
MS-DOS version where they would otherwise be unable to.
SETVER is "self modifying," that is, the location of the SETVER version
table is inside the SETVER.EXE file. Under certain circumstances, it is
possible for the file to become corrupted.
MORE INFORMATION
If you add a new program to the SETVER table and the length of the previous
entries plus the length of the new entry equals 2048 bytes (the maximum
size of the version table), SETVER reports that the program was added
successfully. However, the program is not in fact added, and the table is
corrupted. SETVER returns an ERRORLEVEL code of 0 (zero). If you issue the
SETVER command, the corrupted table is displayed and the new entry is not
shown on the table.
If you attempt to add another program, SETVER returns an ERRORLEVEL code
of 11, which indicates to a corrupted version table.
If an addition exceeds the 2048- byte limit, the message "There is no more
space in version table new entries" appears, and the return code is 14.
| Modification Type: | Major | Last Reviewed: | 5/12/2003 |
|---|
| Keywords: | KB74765 |
|---|
|