Read-Only Calendar Data File Cannot Use Save As Command (71251)
The information in this article applies to:
- Microsoft Windows 3.0
- Microsoft Windows 3.0a
- Microsoft Windows 3.1
- Microsoft Windows 3.11
This article was previously published under Q71251
If you load a read-only .CAL data file into Calendar and then select the
File Menu Save As command, an error message similar to the following is
displayed.
Cannot Save File;
Check to ensure the path and filename are correct and,
if applicable, the network is running.
To save the file, you must remove the file's read-only attribute. You can
do this with the MS-DOS Attrib command, as follows:
where <filename.cal> is the name of the read-only .CAL data file.
| Modification Type: | Minor | Last Reviewed: | 7/7/2005 |
|---|
| Keywords: | KB71251 |
|---|
|