Automating Network Pointing Devices via SETUP.INF (69968)

MORE INFORMATION

Use the following outline to add additional pointing device drivers via the SETUP.INF file.

1. Copy the appropriate Windows 3.00 device drivers into the shared Windows directory.
2. Edit the SETUP.INF file with a standard ASCII text editor and locate the pointing.device section:

         [pointing.device]
   
         Identifier=x:drivename, "Description", x:virtualdrivername,
         dosdriver
   
   Parameter         Description
   ----------       ------------
   <BR/><BR/>
   Identifier       Driver short name
   drivername       Driver filename ending in .DRV
   Description      Title of driver used at setup
   Virtualdriver    (VMD) Most pointing devices use the internal driver
                    in WIN386.EXE, but the manufacturer may supply one
                    that will end in .386, e.g. "1:summa.386"
   
   Dosdriver        Pointing device driver in the CONFIG.SYS or
                    AUTOEXEC.BAT that will be replaced by new version if
                    selected (for example, replace old MOUSE.SYS with new
                    version)
   						

3. Add a blank line to the end of this section, and, on it, enter the additional driver.

Example

To add the following two drivers, SUMMA.DRV and SUMMA.386, add the new line as follows:

   Summa = 1:SUMMA.DRV, "Summa IS/100", 1:SUMMA.386
				

The "1:" or "x:" is showing disk number, where driver is located. On network installations this is not valid.

The SETUP.INF file is a comma-delineated text file formatted for 160 columns that supplies customized directions to the SETUP.EXE.

Preferred Workstation Setup Method

Install Windows 3.0 on a network (see pages 543-556 of the "Microsoft Windows User's Guide"), and then run the SETUP /N command on each workstation. In some instances (for example, large workstation groups) it may not be efficient to do this and then customize each workstation individually. By editing the SETUP.INF file with a text editor, it is possible to enhance the SETUP /N command so that it customizes each workstation to a company standard.