Add Printer Button in Control Panel Not Working (68343)
The information in this article applies to:
- Microsoft Windows 3.0
- Microsoft Windows 3.1
- Microsoft Windows 3.11
This article was previously published under Q68343 SYMPTOMS
When you choose the Add Printer button in the Printers dialog box of
Control Panel, nothing happens, or you receive the following error message:
Information file not in system directory or corrupt.
Copy in CONTROL.INF and SETUP.INF from disk #1.
CAUSE
The following problems can cause this symptom:
- You do not have enough memory to display the printer list.
- The SETUP.INF or CONTROL.INF file is corrupted or has been deleted.
- The SETUP.INF file of another application has been installed over the
Windows SETUP.INF.
- There is a copy of SETUP.INF in the Windows directory as well as the
Windows SYSTEM subdirectory.
- You are loading Intel Net Satisfaction terminate-and-stay-resident
(TSR) programs from your Novell NetWare System Login Script.
WORKAROUND
Use one of the following procedures to correct this problem.
Low Memory
If you suspect that there is not enough memory to display the printer
list, proceed as follows:
- Exit Control Panel.
- Close one or more applications.
- Restart Control Panel and try to add the printer again.
Missing or Corrupted SETUP.INF or CONTROL.INF File
Windows looks first in the Windows directory. If the SETUP.INF or
CONTROL.INF file is not found, it looks in the Windows SYSTEM subdirectory.
If you suspect that the SETUP.INF or CONTROL.INF file in the Windows
SYSTEM subdirectory is corrupted (or is missing), proceed as follows:
- Exit the Control Panel and run File Manager.
- Copy the SETUP.INF and/or CONTROL.INF file from your Windows
installation disks to the Windows SYSTEM subdirectory. (The SETUP.INF
file is located on Disk 1. The CONTROL.INF file is located on Disk 5 of
the 3.5-inch set and on Disk 6 of the 5.25-inch set.)
- Restart the Control Panel and try to add the printer again.
NOTE: The SETUP.INF and CONTROL.INF files are not compressed files and
can be copied without using the EXPAND utility.
Incorrect Version of SETUP.INF File- Verify that the SETUP.INF file is the correct version for Windows
by comparing the file contents with the original SETUP.INF file on your
Windows installation disks.
- If there appears to be a dramatic difference between the two files, back
up your current SETUP.INF file by saving it to a floppy disk or renaming
it.
- Replace the current SETUP.INF file with the original SETUP.INF. You may
need to manually edit the new SETUP.INF and make some changes.
- Restart Control Panel and try to add the printer again.
Multiple SETUP.INF Files
If there are identical copies of SETUP.INF in the Windows and Windows
SYSTEM subdirectory, delete the SETUP.INF file from the Windows directory.
If the SETUP.INF file is in the Windows directory, but not the Windows
SYSTEM directory, move the file to the Windows SYSTEM directory.
REFERENCES
For more information about adding a printer, refer to "Installing a
Printer" in the Microsoft Windows "User's Guide" for version 3.0 or 3.1.
Modification Type: | Minor | Last Reviewed: | 7/7/2005 |
---|
Keywords: | KB68343 |
---|
|