Novell XMSNETx.COM and EMSNETx.COM with Windows (64508)


The information in this article applies to:

  • Microsoft Windows 3.0
  • Microsoft Windows 3.1
  • Microsoft Windows 3.11
This article was previously published under Q64508

SUMMARY

This article discusses compatibility issues with Novell Netware and Microsoft Windows.

In the following information, "x" in the driver names refers the MS-DOS version being used at the workstation in question. For example, if the workstation is running MS-DOS 4.01, then NET4.COM should be used.

MORE INFORMATION

XMSNET.COM or EMSNETX.COM and Windows 3.0

If you encounter problems while using Novell NetWare's XMSNETx.COM or EMSNETx.COM in conjunction with Microsoft Windows version 3.0 or 3.0a, try using the NETx.COM instead. If the symptoms disappear after this change is made, please report the problem to Novell through the regular support channels or by calling Novell.

XMSNET.COM or EMSNETX.COM and Windows 3.1

It has been reported that when you run under Microsoft Windows 3.1, the XMSNETx.COM shell works fine in all modes. However, XMSNETx.COM can cause
Out of Memory
errors with Windows 3.1 after multiple Windows sessions. After you enter and exit Windows 3.1 three or more times with XMSNETx.COM loaded, the errors appear and Windows cannot run until you reboot the system. To prevent this problem, use NETx.COM instead of XMSNETx.com.

MSNETx.COM is NOT supported with Windows 3.1 in 386 enhanced mode. These Novell XMSNETx.COM and EMSNETx.COM drivers have been updated for Windows 3.1, and should be available from your local Novell NetWare dealer.
Modification Type:MinorLast Reviewed:7/7/2005
Keywords:KB64508
©2004 Microsoft Corporation. All rights reserved.