Wireless IntelliMouse Explorer Requires a USB Port (323923)


The information in this article applies to:

  • Microsoft Wireless Intellimouse Explorer USB
This article was previously published under Q323923

SUMMARY

The Wireless IntelliMouse Explorer must be connected to a universal serial bus (USB) port. It is not compatible with PS/2 ports or serial ports.

NOTE: If you try to connect the Wireless IntelliMouse Explorer to a PS/2 port or serial port by using an adapter, you may receive the following error message when you start your computer:
No mouse found.
If your computer does not have a USB port, you may be able to install a USB-to-PCI interface card or a USB-to-PCMCIA interface card that will add a USB port to your computer. Contact your computer retailer for more information.

MORE INFORMATION

For additional information about the system requirements for the Wireless IntelliMouse Explorer USB, click the article number below to view the article in the Microsoft Knowledge Base:

317910 Wireless IntelliMouse Explorer: Minimum System Requirements

NOTE: The system requirements to install Microsoft Internet Explorer 5.5 are listed on the Wireless IntelliMouse Explorer box. The system requirements to install Internet Explorer 5.5 make reference to the Windows 95 and Windows NT operating systems, but this does not mean that the Wireless IntelliMouse Explorer is compatible with these operating systems.
Modification Type:MinorLast Reviewed:1/7/2006
Keywords:kberrmsg kbinfo KB323923
©2004 Microsoft Corporation. All rights reserved.