MCSE Training Kit Designing Highly Available Web Solutions with Microsoft Windows 2000 Server Technologies Comments And Corrections (308657)



The information in this article applies to:

  • MSPRESS MCSE Training Kit, Designing Highly Available Web Solutions With Microsoft Windows 2000 Server Technologies ISBN 0-7356-1425-3

This article was previously published under Q308657

SUMMARY

This article contains comments, corrections, and information about known errors relating to the Microsoft Press book MCSE Training Kit Designing Highly Available Web Solutions with Microsoft Windows 2000 Server Technologies, ISBN 0-7356-1425-3.

The following topics are covered:

  • CD-ROM: Evaluation CD May Not Be Bootable
  • Page xxii: Incorrect Step 2
  • Page 20: Incorrect URL

MORE INFORMATION

CD-ROM: Evaluation CD May Not Be Bootable

Some of the Windows 2000 Server Evaluation Edition CDs included with this book may not be bootable. In order to install Windows 2000 Server using the non-bootable Evaluation CD, you must create Windows 2000 Server Setup Boot Disks.

For instructions on how to create the Windows 2000 Server Setup Boot Disks, please refer to the ADVSRV3.TXTfile located on the Evaluation CD:

"To start Setup for a new installation by starting the computer from floppy disks
1. Locate both the Windows 2000 Setup floppy disks and the Windows 2000 CD-ROM.
2. With your computer turned off, insert the first Setup disk into drive A of your computer.
3. Turn on your computer.
4. Follow the Setup instructions.

You can create a set of floppy disks by using the Makeboot utility in the Bootdisk folder of the Windows 2000 Setup CD-ROM. You can create the Setup disks from a computer running any version of Windows or MS-DOS.

You will need four blank, formatted, 3.5-inch, 1.44-MB floppy disks. Label them Setup Disk One, Setup Disk Two, Setup Disk Three, and Setup Disk Four. To create Setup disks
1. Insert a blank, formatted, 3.5-inch, 1.44-MB disk into the floppy disk drive.
2. Insert the Windows 2000 CD-ROM into the CD-ROM drive.
3. Click Start, and then click Run.
4. In the Open box, type d:\bootdisk\makeboot a: (where d: is the drive letter assigned to your CD-ROM drive), and then click OK.
5. Follow the screen prompts."

Page xxii: Incorrect Step 2

On page xxii, under "To install Application Center 2000 Evaluation Edition",

Change:
"2. Select Run from the Start menu on your desktop, and type D:\Setup.exe..."

To:
"2. Select Run from the Start menu on your desktop, and type D:\AC2000EVL\Setup.exe..."

Page 20: Incorrect URL

On page 20,

Change:
http://www.microsoft.com/technet/ecommerce/ecseries.asp
				

To:
http://www.microsoft.com/traincert/default.asp
				

Microsoft Press is committed to providing informative and accurate books. All comments and corrections listed above are ready for inclusion in future printings of this book. If you have a later printing of this book, it may already contain most or all of the above corrections.

Modification Type:MinorLast Reviewed:7/24/2003
Keywords:kbdocerr kbdocfix kbinfo KB308657