The Services snap-in times out with error 1053 (307806)
The information in this article applies to:
- Microsoft Win32 Application Programming Interface (API), when used with:
- the operating system: Microsoft Windows 2000
- the operating system: Microsoft Windows XP
This article was previously published under Q307806 SYMPTOMS
The Microsoft Management Console (MMC) Services snap-in will wait up to 125 seconds for a service control operation to finish. If the operation has not completed within this time limit, the following error message will appear:
Error 1053: The service did not respond to the start or control request
in a timely fashion.
NOTE: This error message does not indicate that an error has actually occurred within the service. It simply means that the Services snap-in has timed out. The service process will continue to run until the operation has completed.
STATUS
This behavior is by design.
MORE INFORMATION
The MMC Services snap-in can be used to control services. This snap-in allows a system administrator to start, stop, pause, resume, or restart a service.
When any control operation is initiated, the Services snap-in displays a progress dialog box with the title "Service Control". If a service requires a significant amount of time to process an operation, the progress bar will slowly increment as the Services snap-in waits for the operation to finish. After 125 seconds, the progress bar will be full and the Services snap-in will display the error 1053 (ERROR_SERVICE_REQUEST_TIMEOUT) message. The service process itself will continue its operation as usual even after the error message has appeared.
The 125-second timeout within the Services snap-in is a hard-coded limit and cannot be changed through the registry.
The Service Control dialog box contains a Close button. If the dialog box is closed before the wait limit has expired, the error message will not be displayed.
| Modification Type: | Major | Last Reviewed: | 5/19/2005 |
|---|
| Keywords: | kbKernBase kbprb kbService KB307806 |
|---|
|