BUG: Cannot Create Multiple Selection Criteria with the Same Name for Document Definitions (302860)


The information in this article applies to:

  • Microsoft BizTalk Server 2000
This article was previously published under Q302860

SYMPTOMS

If you create multiple selection criteria with the same name for a document definition in the BizTalk Messaging Manager, only the most recently created criteria per specific name remains after you save the document definition. The Messaging Manager does not generate a warning message to indicate that any selection criteria are being removed. There is no way to create multiple selection criteria with the same name by using the Messaging Manager.

CAUSE

The Microsoft BizTalk Messaging Manager does not allow multiple selection criteria with the same name to be created for a document definition.

STATUS

Microsoft has confirmed that this is a problem in BizTalk Server 2000.

MORE INFORMATION

Steps to Reproduce This Behavior:
  1. Open the BizTalk Messaging Manager, and then add a new document definition.
  2. In the Document Definition Properties Wizard, click the Selection Criteria tab.
  3. Add several criteria with some that share the same name.
  4. Save the document definition.
  5. Open the document definition again.
Result: Although there are no warnings, not all of the selection criteria appear.
Modification Type:MajorLast Reviewed:9/30/2003
Keywords:kbbug kbnofix KB302860
©2003 Microsoft Corporation. All rights reserved.