XFOR: Full Reload When You Modify Trust Value on Exported Containers Tab (300458)


The information in this article applies to:

  • Microsoft Exchange Server 5.5
This article was previously published under Q300458

SYMPTOMS

When you modify the Trust level value on the Exported Containers tab in Microsoft Exchange Connector for Lotus Notes, a full export will take place on the next scheduled reload. This behavior may be unexpected and cause a larger-than-normal replication process.

WORKAROUND

To work around this issue, follow these steps:
  1. At the command prompt, type the following

    drive letter:\exchsrvr\CONNECT\Exchconn>LSDXA -P CONTROL-SERVICE -N LME-NOTES,GWISE or SNADS-DXA -C EXCHCONN.INI /W0

    to produce the Eab.txt file in the following directory:

    Exchsrvr\connect\exchconn\temp

    Note that this process may take a very long time.
  2. Change the first line of the Eab.txt file from "Load" to Updates.

    If you do not make this change, all entries not listed in the intermediate file will be deleted.
  3. Remove all of the entries that are already in the foreign system.

    Each entry starts with a "U" or an "A."
  4. Run the following command line to "read" the entries into the foreign directory system:

    drive letter:\exchsrvr\CONNECT\Exchconn>LSDXA -P CONTROL-SERVICE -N LME-NOTES,GWISE or SNADS-DXA -C EXCHCONN.INI /R1

STATUS

This behavior is by design.
Modification Type:MinorLast Reviewed:4/25/2005
Keywords:kbprb KB300458
©2004 Microsoft Corporation. All rights reserved.