Clip2002: Unable to Click and Drag to Select Multiple Clips in Thumbnails View (279483)
The information in this article applies to:
- Microsoft Clip Organizer 2002
This article was previously published under Q279483 SYMPTOMS
When you attempt to click and drag to select multiple clips in Microsoft Clip Organizer, you may not receive a Select box as expected, in which case only one clip is selected.
CAUSE
This behavior can occur if the clips are viewed in Thumbnails view. Clip Organizer does not support click-and-drag selection of clips in Thumbnails view.
WORKAROUND
To work around this issue, follow these steps:
- On the Insert menu, point to Picture, and then click Clip Art.
- Start Clip Organizer by clicking Clip Organizer in the Insert Clip Art task pane.
- Select the folder that contains the clips that you want in the Collection List window.
- To select multiple clips in a collection, use one of the following methods:
- On the Edit menu, click Select All.
-or- - While pressing the CTRL key, click each each clip that you want.
-or- - Click the first clip that you want, press the SHIFT key, and then click the last clip that you want.
The first and last clips that you clicked are selected, as well as all clips in between.
-or- - While holding down CTRL, press the A key.
This is a shortcut to clicking Select All on the Edit menu.
| Modification Type: | Major | Last Reviewed: | 5/3/2001 |
|---|
| Keywords: | kbprb KB279483 |
|---|
|