You Are Unable to Filter Between Two Internet Protocol Addresses in Network Monitor 2.0 (279354)

The information in this article applies to:

Microsoft Windows 2000 Server
Microsoft Windows 2000 Advanced Server
Microsoft Windows 2000 Professional

This article was previously published under Q279354

SYMPTOMS

After you set a capture filter in Network Monitor version 2.0 to filter between a pair of Internet Protocol (IP) addresses, no frames are captured. Also, this may occur even when there is IP traffic being sent to and from the IP addresses that you specified in the capture filter.

RESOLUTION

To resolve this problem, obtain the latest service pack for Windows 2000. For additional information, click the following article number to view the article in the Microsoft Knowledge Base:

260910 How to Obtain the Latest Windows 2000 Service Pack

The English version of this fix should have the following file attributes or later:

   Date       Time     Version        Size     File name
   -----------------------------------------------------
   11/10/00   10:58pm  5.0.2195.2709  37,488   Nmnt.sys

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article. This problem was first corrected in Windows 2000 Service Pack 2.

MORE INFORMATION

For additional information about how to set capture filters in Network Monitor, click the article number below to view the article in the Microsoft Knowledge Base:

148942 How to Capture Network Traffic with Network Monitor

For additional information about how to install Windows 2000 and Windows 2000 hotfixes at the same time, click the article number below to view the article in the Microsoft Knowledge Base:

249149 Installing Microsoft Windows 2000 and Windows 2000 Hotfixes

Modification Type:	Minor	Last Reviewed:	9/26/2005
Keywords:	kbHotfixServer kbQFE kbbug kbenv kbfix kbnetwork kbWin2000PreSP2Fix KB279354