The Default Settings For Brightness and Contrast Cannot Be Applied To All Scanned Pictures (267452)


The information in this article applies to:

  • Microsoft Windows Millennium Edition
This article was previously published under Q267452
If this article does not describe your hardware-related issue, please see the following Microsoft Web site to view more articles about hardware:

http://support.microsoft.com/default.aspx/w98?sid=460

SYMPTOMS

After you install a scanner and run Scanner and Camera Wizard, when you click Adjust the quality of the scanned picture, you may not be able to change the default settings for brightness and contrast for all the scanned pictures.

WORKAROUND

To work around this behavior, change the brightness and contrast for each picture by following these steps:
  1. Click Start, point to Programs, point to Accessories, and then click Scanner and Camera Wizard.
  2. Click Next.
  3. Click Adjust the quality of the scanned picture.
  4. On the Advanced Properties box, adjust the brightness and contrast settings by moving the slider to the left or to the right.

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.
Modification Type:MajorLast Reviewed:7/13/2006
Keywords:kbprb KB267452
©2004 Microsoft Corporation. All rights reserved.