How RDISK.EXE Updates Repair Information (265422)


The information in this article applies to:

  • Microsoft Windows NT Server 4.0
  • Microsoft Windows NT Workstation 4.0
This article was previously published under Q265422

SUMMARY

This article describes how the RDISK.EXE utility updates repair information.

MORE INFORMATION

The following changes occur to the repair directory when you update the repair information:
  1. System._ is deleted.
  2. $$Hive$$.tmp is created. (This is the system hive being regenerated.)
  3. Some DC##.tmp files are generated in the user's Home directory. If the user does not have a Home directory, the files are generated on the root directory of the partition. There will be five DC##.tmp files created and then deleted for each new hive that is generated.
  4. $$Hive$$.tmp is compressed and called System._.
  5. Software._ is deleted.
  6. $$Hive$$.tmp is created. (This is the software hive being regenerated.)
  7. $$Hive$$.tmp is compressed and called Software._.
  8. Ntuser.da_ is deleted.
  9. $$Hive$$.tmp file is created. (This is the default user profile being generated by copying Winnt\Profiles\Default user\Ntuser.dat.)
  10. $$Hive$$.tmp is compressed and called Ntuser.da_. (All other files remain untouched unless rdisk -s is used; in that case, Sam._ and Security._ are also replaced.)
  11. You are prompted to make an Emergency Repair Disk (ERD).
  12. If you reply Yes, all the files in the repair directory are copied to the ERD.
Modification Type:MajorLast Reviewed:8/8/2001
Keywords:kbinfo KB265422
©2002 Microsoft Corporation. All rights reserved.