Visio2000: CAD Converter Fails to Convert CAD Drawings When You Use Process Engineering Shape Conversion Wizard (264449)


The information in this article applies to:

  • Microsoft Visio 2000 Technical Edition
This article was previously published under Q264449

SYMPTOMS

In Visio 2000 Technical Edition, when you try to convert a CAD drawing by using the Process Engineering Shape Conversion Wizard, the CAD file fails to convert, and you receive the following error message:
The following file cannot be converted: (Filename and file path) Automation error

RESOLUTION

To resolve this problem, obtain Microsoft Visio 2000 Service Release 1 (SR-1).

To obtain SR-1, click the article number below to view the article in the Microsoft Knowledge Base:

263721 Visio: How to Obtain Microsoft Visio 2000 Service Release 1 (SR-1)

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.  This problem was corrected in Microsoft Visio 2000 SR-1.

MORE INFORMATION

Steps to Reproduce the Behavior

  1. Open the Process Engineering solution.
  2. On the Process Engineering menu, click Shape Conversion Wizard.
  3. Click CAD symbols from one or more files.
  4. Browse to and then select any CAD file.

    Note that the CAD file is not converted, and that you receive the error message mentioned in the "Symptoms" section.
Modification Type:MajorLast Reviewed:11/4/2002
Keywords:kberrmsg KB264449
©2002 Microsoft Corporation. All rights reserved.